China-Temperaturregler: Bitte um Rat/Erklärung zu Einstellungen bzw. Funktion

[Manf]

Ich habe nur schnell mal die Beschreibung angesehen:
Nehmen wir die Schalter:
TFL
TP1 TP2
BF1 BF2

Für eine Grundfunktion interessieren die Schalter:
TFL sorgt für Grund PWN von 20% oder 40% ist also beliebig (oder vielleicht eher niedriges Geräusch).
TP1 TP2 stellen die Temperatur ein 35° 40° 50° 60° jeweils mit Bereich drüber.
BF1 und BF2 sorgen für stall Alarm bei Lüfter 1 und 2.

Ich würde die Schaltung erst einmal mit Fühler und Fan1 ausprobieren, eben mit einem passenden Fan mit PWM Steuerung.



Andere Quelle:

description
100% brand new and high quality.
Feature:
function setting switch description (after modifying any setting, it must be restarted before it takes effect):

TFL (No. 1): Temperature-controlled channel start PWM setting, on state when FAN1 start PWM is 40%,off State FAN1 start PWM is 20%.

TP1 TP2 (number 2,3): Temperature control channel controlled temperature zone, the specific settings are as follows (need to use with temperature probe):
TP1 / TP2 / acceleration temperature / full Speed temperature

off / off / 35℃ / 45 ℃
on / off / 40℃ / 55 ℃
off / on / 50℃ / 70 ℃
on / on / 60℃ / 90 ℃

Lower than the acceleration temperature at the starting speed signal output, exceeding full speed temperature is always output at full speed. BF1 BF2 (number 4,5): corresponding to FAN1 FAN2 stop alarm function switch, when the corresponding open, the channel fan failure stop, the controller will sound (need to match the buzzer) light alarm, the fan after the rotation of the alarm automatic elimination.

If both BF1 and BF2 are on, then there is one or two stops in FAN1, FAN2, and the controller will alarm!

Basic parameters:
Board Size: Length-width height 50mm*43mm*13mm, locating hole position 44mm*37mm, diameter 3mm
Weight: 13.5g Piece of board

Operating voltage: DC12V circuit load capacity: 4A per channel support, bus current is not more than 9A
Output Range: First 20%-100 or 40%-100 (tfl=on)
Second and Third Road 10%-100

Note: The above range is only PWM range, the actual fan control effect will vary depending on the fan.
Temperature probe parameters: 50K b=3950
Temperature Zone Error: According to the temperature probe error, general 3-5% Stop-turn alarm speed threshold: 700-800 rpm
Please note that the controller is a four-wire PWM fan controller, only the four-line fan (all chassis and CPU four-wire fans are compliant, the server is controlled with a violent fan of 97%) and cannot control two or three-wire fans, unable to completely shut down the fan.