hey, danke für deine Antwort


ups, is mir garnicht aufgefallen, hier der Empfänger Code:


Code:
// Arduino Nano alias Empfänger - Version 2

#include <Servo.h>
#include <SPI.h>
#include "RF24.h"

Servo myservo; // create servo object to control a servo

//Контакты от радиомодуля NRF24L01 подключаем к пинамнам -> Arduino

//SCK -> 13//MISO -> 12//MOSI -> 11//CSN -> 10//CE -> 9

// Set up nRF24L01 radio on SPI bus plus pins 9 & 10

RF24 radio(9,10);

const uint64_t pipe = 0xE8E8F0F0E1LL; // адрес канала

int msg[1];

void setup()

{

  // Serial.begin(9600);

  myservo.attach(3); // attaches the servo on pin 3 to the servo object

  radio.begin();

  radio.openReadingPipe(1,pipe); // Открываем один из 6-ти каналов приема

  radio.startListening(); // Начинаем слушать эфир
}

void loop()

{
  if (radio.available())
  {

    bool done = false;
    while (!done)
  {

  done = radio.read(msg, 1);

  myservo.write (msg[0]);

  //Serial.println(msg[0]);
  
    }

  }

}
Ist der Code aber schon für zwei Joystick´s / Potis ?
Weil ja nur einmal:

const int potPin = 0

drin steht.

Ansogst leuchtet es mir ein was du geändert hast.
Schade das es kein Deutsches Tutorial gibt ......