Kann man das in die Loop Schleife packen,ohne dass der Servo ständig hin und her dreht? Also sich nur einmal dreht,die Position hält und dann der nächste Ablauf kommt.
Ich habs mal so Ausprobiert,hat aber nicht geklappt:

//*Sweep
//*by*BARRAGAN*<http://barraganstudio.com>*
//*This*example*code*is*in*the*public*domain.


#include*<Servo.h>
*
Servo myservo; // create servo object to control a servo
****************// a maximum of eight servo objects can be created
*
int pos = 0; // variable to store the servo position
*
void setup()
{*
**myservo.attach(5); // attaches the servo on pin 9 to the servo object

**myservo.attach(4); // attaches the servo on pin 9 to the servo object
}*
*
*
*
void loop()
{*
**for(pos = 0; pos < 80; pos += 1) // goes from 0 degrees to 180 degrees
**{**********************************// in steps of 1 degree
****myservo.write(pos); // tell servo to go to position in variable 'pos'
****delay(15); // waits 15ms for the servo to reach the position
**}*
**
**for(pos = 0; pos < 70; pos += 1) // goes from 0 degrees to 180 degrees
**{**********************************// in steps of 1 degree
****myservo.write(pos); // tell servo to go to position in variable 'pos'
****delay(15); // waits 15ms for the servo to reach the position
**}*
}*