Edit: Scheinbar ist es doch nicht ganz so einfach... Hier die Log-Datei:
Nach Reset+Enable Passthrough kommt:Code:RobotLoader is ready to go. #### Network close all... #### Network close all done! #### BEGIN CONNECT TO: 192.168.2.60:2000 Network Connection Timeout ERROR (101) ||| Network Connection attempt timed out! #### Network close all... #### Network close all done! #### DISCONNECTED #### Network close all... #### Network close all done! #### BEGIN CONNECT TO: 192.168.2.60:2000 #### CONNECTED TO HOST: 192.168.2.60:2000 Try to get ID... Reset Microcontroller... WAIT RESPONSE TIMEOUT!!!! RETRY FAILURE! Please run again manually! Enter CMD Mode not OK, try again... ############# NETLOAD TIMEOUT! Reconnect... #### Network close all... #### Network close all done! #### BEGIN CONNECT TO: 192.168.2.60:2000 Connection interrupted! RESET MCU FAILED! CONNECTION ERROR! ########### Action failed! Abort. Please retry manually. If this fails, check settings! Network Connection Timeout ERROR (101) ||| Network Connection attempt timed out! #### Network close all... #### Network close all done! #### DISCONNECTED
Und hier der Rest:Code:WiFly Ver 2.32, 02-13-2012 on RN-171 MAC Addr=00:06:66:72:03:4d Auto-Assoc ***************** chan=1 mode=************ SCAN OK Joining ****************** now.. *READY* Associated! Using Static IP Listen on 2000
Den Router habe ich auch neu gestartet, wie gesagt ohne Erfolg... Mal geht es, mal geht es nicht - und vor Kurzem ging es noch problemlos.Code:.$$$ Enter Command Mode... CMD # show rssi show rssi RSSI=(-48 ) dBm <2.32> # show net show net SSid=*********************** Chan=1 Assoc=OK Rate=8, 6 Mb Auth=OK Mode=******* DHCP=OK Boot=147 Time=FAIL Links=1 <2.32> # show status show status Conns=0, WRX=0/0, WTX=0/0, RTRY=0, RTRYfail=0 URX=6, UTX=279, RXdrop=0, RXerr=0, FlwSet=0, FlwClr=0 TX-UDP=0, netbufs=0, evt=0, adhoc_lost=0 Boots=1, Wdogs=0,TXon=1 <2.32> # get wlan get wlan SSID=****************** Chan=0 ExtAnt=0 Join=1 Auth=********* Mask=0x1fff Rate=8, 6 Mb Linkmon=5 Passphrase=****** TxPower=0 <2.32> # get ip get ip IF=UP DHCP=OFF IP=192.168.2.60:2000 NM=255.255.255.0 GW=192.168.2.1 HOST=0.0.0.0:2000 PROTO=TCP, MTU=1524 FLAGS=0x7 TCPMODE=0x0 BACKUP=0.0.0.0 <2.32> # get comm get comm OPEN=*OPEN* CLOSE=*CLOS* REMOTE= FlushSize=1024 MatchChar=0 FlushTimer=10 IdleTimer=0 CmdChar=$ <2.32> # scan scan <2.32> SCAN:Found 5 Num SSID Ch RSSI Sec MAC Address Suites Andere Netzwerke habe ich rausgenommen! 2 **************** 01 -47 WPA2PSK ********************* AESM-AES WPSPB 3100
Zitieren
Lesezeichen