also bis hier hin bin ich gekommen:
Code:
'KS0108 TG12864B
' Pin LCD - Pin Atmega
' 1  Vss          9V oder 5V
' 2  VDD          5V?
' 3  V0           GND
' 4  D/I
' 5  R/W          Port C0
' 6  E            Enable also 5V?
' 7  DB0          Port A0
' 8  DB1          Port A1
' 9  DB2          Port A2
'10  DB3          Port A3
'11  DB4          Port A4
'12  DB5          Port A5
'13  DB6          Port A6
'14  DB7          Port A7
'15  CS1
'16  CS2
'17  RST          Reset?
'18  VEE          Kontrast?
'19  K            LED - also GND
'20  A            LED + also 5V
Abgeschaut von hier : https://www.roboternetz.de/wissen/in...D-Modul_am_AVR

Aber es gibt noch ein paar Lücken , wo ich nicht weiß wie ich die verbleibenden Pins anschließen soll.