Steckernetzteil verwendet und siehe da:

nitro@nitro-desktop:~/Desktop/atmega8-hello/first_hello$ sudo avrdude -P /dev/ttyS0 -p m16 -c ponyser -U flash:w:./hello.hex

avrdude: AVR device initialized and ready to accept instructions

Reading | ################################################## | 100% 0.00s

avrdude: Device signature = 0x1e9403
avrdude: NOTE: FLASH memory has been specified, an erase cycle will be performed
To disable this feature, specify the -D option.
avrdude: erasing chip
avrdude: reading input file "./hello.hex"
avrdude: input file ./hello.hex auto detected as Intel Hex
avrdude: writing flash (350 bytes):

Writing | ################################################## | 100% 0.25s

avrdude: 350 bytes of flash written
avrdude: verifying flash memory against ./hello.hex:
avrdude: load data flash data from input file ./hello.hex:
avrdude: input file ./hello.hex auto detected as Intel Hex
avrdude: input file ./hello.hex contains 350 bytes
avrdude: reading on-chip flash data:

Reading | ################################################## | 100% 0.23s

avrdude: verifying ...
avrdude: 350 bytes of flash verified

avrdude: safemode: Fuses OK

avrdude done. Thank you.


Die Schaltung ist hochsensibel wenn das serielle Kabel noch nicht angeschlossen ist... aber jetzt funzt alles, wochenende ist gerettet!!

Ich danke euch allen
\/