Hi, ich hab vor kurzem mein RN-Control Board (V1.4) bekommen und möchte nach ein paar LED tests einen LDR mittels ADC auswerten.
Doch auch mit der Suche und der RN-Wissensdatenbank bin ich nicht weitergekommen.
Meine Schaltung sieht folgendermaßen aus. Den LDR hab ich an einen der 3 VCC pins (JP1 Leiste) und an den 1. Stecker von Port 1 angeschlossen. (Ich hoffe soweit richtig)

Jetzt mein Source, der nicht funktioniert.



Code:
$regfile = "m32def.dat"
$framesize = 32
$swstack = 32
$hwstack = 32
$crystal = 16000000
$baud = 9600

Config Portc.0 = Output
Config Portc.1 = Output
Config Portc.2 = Output
Config Portc.3 = Output
Config Portc.4 = Output
Config Portc.5 = Output
Config Portc.6 = Output
Config Portc.7 = Output


Config Porta = Input



Config Adc = Single , Prescaler = Auto
Dim W As Word , Ch As Long

Dim Port As Long

Tccr1b = Tccr1b Or &H02


Do
Start Adc
  W = Getadc(ch)

  If W > 50 Then
  Portc.0 = 0
  End If
  If W > 200 Then
  Portc.1 = 0
  End If
  If W > 400 Then
  Portc.2 = 0
  End If

  If W < 50 Then
  Portc.7 = 0
  End If


  Ch = Ch + 1
  If Ch > 7 Then
  Ch = 0
  End If


  Waitms 100




Loop

End
Gruß Robin