so jetzt läufts. in der eagle.def, die man im ordner bin findet müssen folgende zeilen hinzugefügt werden:
Code:
[EPS-Drillaid]
@EPS
Long = "Postscript with max hole size in pads/etc, ala drill-aid.ulp"
Header3 = "%% redefine our /h function with a fixed diameter\n"\
"/h { %% draw a hole\n"\
" /d exch def\n %% Still need to pop diam off stack\n"\
" d 5000 gt {\n"\
" /d 5000 def\n %% But override it to 0.5mm\n"\
" } if\n"\
" /y exch def\n"\
" /x exch def\n"\
" d 0 gt {\n"\
" newpath\n"\
" x EU y EU d 2 div EU 0 360 arc\n"\
" currentgray dup\n"\
" 1 exch sub setgray\n"\
" fill\n"\
" setgray\n"\
" } if\n"\
" } def\n"\
"%% The drawing\n"
[PS-Drillaid]
@PS
Long = "Postscript (printable) with max hold size ala Drill-aid.ulp"
Header2 = "%% redefine our /h function with a fixed diameter\n"\
"/h { %% draw a hole\n"\
" /d exch def\n %% Still need to pop diam off stack\n"\
" d 5000 gt {\n"\
" /d 5000 def\n %% But override it to 0.5mm\n"\
" } if\n"\
" /y exch def\n"\
" /x exch def\n"\
" d 0 gt {\n"\
" newpath\n"\
" x EU y EU d 2 div EU 0 360 arc\n"\
" currentgray dup\n"\
" 1 exch sub setgray\n"\
" fill\n"\
" setgray\n"\
" } if\n"\
" } def\n"\
"%% Remainder of Header2 copied from define for PS device\n"\
"%% the real drawing size:\n"\
"\n"\
"/MinDrawX %6d EU def\n"\
"/MinDrawY %6d EU def\n"\
"/MaxDrawX %6d EU def\n"\
"/MaxDrawY %6d EU def\n"\
"\n"\
"%% the usable page size:\n"\
"\n"\
"/LeftMargin 0.25 inch def %% change these if drawing gets clipped!\n"\
"/BotMargin 0.25 inch def\n"\
"/PageWidth %7.4f inch def\n"\
"/PageHeight %7.4f inch def\n"\
"\n"\
"%% are we going to rotate?:\n"\
"\n"\
"/RotateDrawing %d 0 ne def\n"\
"\n"
;(x1, y1, x2, y2, Width, Height, DoRotate)
im cam-prozessor muss dann das gewünschte device ausgewählt werden und es läuft.
Lesezeichen