Das sollte beim Übersetzen mindestens eine Warnung geben, weil du einen ungültigen SIGNAL-Name verwendest.
https://www.roboternetz.de/wissen/in...nung_ignoriert
Zitat von iom32.h
Code:/* Interrupt vectors */ /* External Interrupt Request 0 */ #define INT0_vect _VECTOR(1) #define SIG_INTERRUPT0 _VECTOR(1) /* External Interrupt Request 1 */ #define INT1_vect _VECTOR(2) #define SIG_INTERRUPT1 _VECTOR(2) /* External Interrupt Request 2 */ #define INT2_vect _VECTOR(3) #define SIG_INTERRUPT2 _VECTOR(3) /* Timer/Counter2 Compare Match */ #define TIMER2_COMP_vect _VECTOR(4) #define SIG_OUTPUT_COMPARE2 _VECTOR(4) /* Timer/Counter2 Overflow */ #define TIMER2_OVF_vect _VECTOR(5) #define SIG_OVERFLOW2 _VECTOR(5) /* Timer/Counter1 Capture Event */ #define TIMER1_CAPT_vect _VECTOR(6) #define SIG_INPUT_CAPTURE1 _VECTOR(6) /* Timer/Counter1 Compare Match A */ #define TIMER1_COMPA_vect _VECTOR(7) #define SIG_OUTPUT_COMPARE1A _VECTOR(7) /* Timer/Counter1 Compare Match B */ #define TIMER1_COMPB_vect _VECTOR(8) #define SIG_OUTPUT_COMPARE1B _VECTOR(8) /* Timer/Counter1 Overflow */ #define TIMER1_OVF_vect _VECTOR(9) #define SIG_OVERFLOW1 _VECTOR(9) /* Timer/Counter0 Compare Match */ #define TIMER0_COMP_vect _VECTOR(10) #define SIG_OUTPUT_COMPARE0 _VECTOR(10) /* Timer/Counter0 Overflow */ #define TIMER0_OVF_vect _VECTOR(11) #define SIG_OVERFLOW0 _VECTOR(11) /* Serial Transfer Complete */ #define SPI_STC_vect _VECTOR(12) #define SIG_SPI _VECTOR(12) /* USART, Rx Complete */ #define USART_RXC_vect _VECTOR(13) #define SIG_USART_RECV _VECTOR(13) #define SIG_UART_RECV _VECTOR(13) /* USART Data Register Empty */ #define USART_UDRE_vect _VECTOR(14) #define SIG_USART_DATA _VECTOR(14) #define SIG_UART_DATA _VECTOR(14) /* USART, Tx Complete */ #define USART_TXC_vect _VECTOR(15) #define SIG_USART_TRANS _VECTOR(15) #define SIG_UART_TRANS _VECTOR(15) /* ADC Conversion Complete */ #define ADC_vect _VECTOR(16) #define SIG_ADC _VECTOR(16) /* EEPROM Ready */ #define EE_RDY_vect _VECTOR(17) #define SIG_EEPROM_READY _VECTOR(17) /* Analog Comparator */ #define ANA_COMP_vect _VECTOR(18) #define SIG_COMPARATOR _VECTOR(18) /* 2-wire Serial Interface */ #define TWI_vect _VECTOR(19) #define SIG_2WIRE_SERIAL _VECTOR(19) /* Store Program Memory Ready */ #define SPM_RDY_vect _VECTOR(20) #define SIG_SPM_READY _VECTOR(20)
Zitieren
Lesezeichen