hallo

versuch es einfach mal so:

Code:
$regfile = "m8def.dat"
$crystal = 7372800                                          'Quarzfrequenz
$baud = 9600
$hwstack = 32
$swstack = 40
$framesize = 32




'_______________________________________________________________________________

 Config Lcdpin = Pin , E = Portc.3 , E2 = Portd.7 , Rs = Portc.2 , Db4 = Portd.2 , Db5 = Portd.3 , Db6 = Portd.4 , Db7 = Portd.5
 Config Lcd = 20 * 4
 Config Pind.6 = Output
 Config Adc = Single , Prescaler = Auto , Reference = Off   'Für Tastenabfrage und Spannungsmessung
 Config Pinc.0 = Input                                      'Für Tastenabfrage
 Portc.0 = 1                                                'Pullup Widerstand ein
 Portd.6 = 0
    Dim ___lcdno As Bit
Initlcd                                          'die beiden unteren Zeilen

Locate 1 , 1
Lcd "1. Die erste Zeile" ;

Locate 2 , 1
Lcd "2. Die zweite Zeile"

Cursor Off

Locate 3 , 1
Lcd "3. Die dritte Zeile" ;

Locate 4 , 1
Lcd "4. Die vierte Zeile"

Cursor Off

End
so müsste es klappen allerdings ist das ein Programm von mir musste noch ändern wahrscheinlich das es bei dir klappt, sprich LCD Pin belegung usw.

gruß
patrick[/code]