Ja aber ich weiß immer noch nicht, was
a) AVR
b) IC2
bedeutet,

und mit welchem Port ich die Relaiskarte nun ansteuern soll und welche Relaiskarte ich mir holen sollte.

Aber das Netzteil ist doch schick

Zitat Zitat von Email von oap.sourceforge.net
Von: Dafydd Walters <dafydd@walters.net>
An: victor@viathinksoft.hn.org
Betreff: Re: Power supply
Datum: Thu, 10 Jun 2004 09:54:11 +0100
Hi Victor,

> How did you do it, that the voltage is ok for the mainboard all the time?
And is the power connector \"PW-70\" compatible with other mainboards, too?
(The producers of the \"PW-70\" says on their website that it\'s designed
for VIA mainboards -> I have a GigaByte mainboard)

I believe it should be compatible with any Mini-ITX form-factor motherboard,
so if your GigaByte board is a Mini-ITX board, you should be OK. However,
don't take my word for it; it's probably best to contact the company that
makes the PW-70 and ask them.

> Second question: Which material do you use for building the platforms
etc.?

I used an off-the-shelf robot platform from Zagros Robotics
(www.zagrosrobotics.com). The Prototype page at the OAP web site
(http://oap.sourceforge.net/prototype.php) has some notes on how it was all
put together, and that page also has a parts-list at the bottom for the
major components.

Regards,
Dafydd Walters.
Ich brauche schon mehr als 8 Outputs! -> Ich möchte ein LCD-Display ansteuern, genauso wie bei oap.sf.net weiß aber nicht so recht, wie ich das machen soll... Aber das ist erstmal Nebensache. Am Anfang möchte ich erstmal ein Motherboard per 12V Akku betreiben und anfangen, die unterste Ebene meines Roboters zu bauen. Dafür muss ich erstmal in den OBI fahren und mir Material besorgen... Welches (schöne, billige) Baumaterial empfiehlt ihr mir (Farbe am besten Schwarz!)

Und was ist denn nun
a) AVR
b) IC2