Hey ich hab da mal ein Problem:
Also ich hab meinen Mega32 nach dem Schaltplan der einfachen Grunschaltung gelötet und per isp-Dongle (stk200/300-Programmer)
mit dem Pc verbunden und 4,5 volt Betriebsspannung dran gelegt...
Wenn ich aber in Bascom ein Programm übertragen will, dann erkennt der den Controller net da kommt sone Meldung:
[schild=16 fontcolor=000000 shadowcolor=C0C0C0 shieldshadow=1]Could not identify Chip with ID:...[/schild]
nja und ich wollt mal Fragen, ob man dafür ein RS232-Kabel braucht, oder ob das nur benötigt wird, wenn man Texte, oder Werte vom Controller am PC ausgeben will...
ich hab echt keine Ahnung...
schonmal thx im Vorraus..